6/3/2023 0 Comments Dolog akf software developer![]() There might be some more information (Modicon has lots of examples for 984LL commands) on your specific card at (). In effect, you need to create your own input multiplexer. This allows you to read some inputs at different rates then other inputs. Then each time you want to read a value you write a value to a different register to tell the card what channels (up to two at a time) to scan and which 3x register to put the each value into. ![]() This usually consisted of writing values into specific 4x registers to tell the card what type of analog signal was going to be seen on each channel as well as what channels will be active (this only had to be done once at each power up). When using the original 984LL software some Modicon analog cards needed to be configured before you could read them. I am not familiar with the software or the specific card you are using, so I don't know the actual commands.
0 Comments
Leave a Reply. |